2021-07-09
Secundum genus: verticaliniectio auro apparatus
In this type of iniectio auro apparatus, the clamping part and the injection part are on the same vertical centerline, and the mold is opened in the vertical direction. Therefore, it occupies a small area, it is easy to place inserts, it is convenient to load and unload molds, and the materials falling from the hopper can be plasticized more uniformly. However, the product is not easy to automatically fall after being ejected, and must be removed by hand, which is not easy to realize automatic operation. Vertical iniectio auro machinis are suitable for small iniectio auro machinis. Generally, iniectio auro machinis below 60 grams are more commonly used, and large and medium-sized machines are not suitable.
The third type: Angle iniectio auro apparatus
The injection direction of the angle iniectio auro apparatus is on the same surface as the mold interface. It is particularly suitable for processing flat products where gate marks are not allowed in the machining center. It occupies a smaller area than a horizontal iniectio auro apparatus, but the inserts placed in the mold are easy to tilt and fall. This type of iniectio auro apparatus is suitable for small machines.
The fourth type: multi-mode turntable iniectio auro apparatus
Est autem specialisiniectio auro apparatus with multi-station operation. Its characteristic is that the mold clamping device adopts a turntable structure, and the mold rotates around the shaft. This type of iniectio auro apparatus gives full play to the plasticizing capacity of the injection device, which can shorten the production cycle and increase the production capacity of the machine.